Thingiverse
portable toothpick box
von stephen_w
10
Downloads
67
Likes
0
Makes
I made a portable toothpick box. Suitable for most toothpicks(Length less than 7mm).Hope this is helpful to everyone.
Reference assembly drawing
It is best to choose a strong spring (Diameter:4mm-5mm, length：20mm-25）I use the spring of the push-button ballpoint pen.
It is best to use tweezers when installing the spring.
Don't fill the toothpick too full, shaking it forward a few times before use.
This model was printed using PLA. (fill in 10%，using a lower layer high 0.2mm)
Reference assembly drawing
It is best to choose a strong spring (Diameter:4mm-5mm, length：20mm-25）I use the spring of the push-button ballpoint pen.
It is best to use tweezers when installing the spring.
Don't fill the toothpick too full, shaking it forward a few times before use.
This model was printed using PLA. (fill in 10%，using a lower layer high 0.2mm)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
