Portafilter Base

此页面分享的是问号盒子的打印文件，奇诺比奥也将会在后续分享出来模型需要胶水完成装配打印之前玩家需要确认自己手柄的尺寸！！！关于如何确定适合的尺寸：测量手柄连接处下沿的最大直径（下图中红色高亮区域的直径） This page shares the files for the Question Block, Kinopio will also be released in future updates.The model requires glue for final assembly.Before printing, users should confirm the size of their portafilter!!!How to determine the correct size:Measure the largest diameter at the bottom of the portafilter (highlighted in red in the image below).手柄下沿最大直径在68mm-69mm可以直接打印使用如果手柄下沿最大直径远远大于或小于这个值，打印文件中提供了通用版本，即没有预先开孔的版本，玩家可以在bambu studio中添加‘负零件’得到自己想要的开孔尺寸： Portafilters with a bottom diameter of 68mm-69mm can be printed and used directly.If the largest bottom diameter of your portafilter is significantly larger or smaller than this value, a generic version without pre-drilled holes is provided in the print files. Users can add ‘negative parts’ in Bambu Studio to customize the hole size to their preference.比如：如果先前得到的值为72mm，则可以添加一个直径为73mm（记得加入公差），高度65mm的圆柱体负零件： For example, if the previously