PoseLight - for LED Lamp Kit

POSELIGHT…The posable light. Had a LED lamp kit laying around and needed a light i could adjust and bend to my tinkering needs, but couldn't find any that was exactly what i wanted. So i just made my own. Isn't that what 3D printing is all about? The model consist of ball joints fixed to a table clamp. The will fit table from 8mm all the way up to 30mm. The middle segments have a groove to allow you to hide the cable inside the assembled “stem”. For this i might make a tool, but personally just used a non sharp piece of metal i had laying around on my desk. Its a rather straight forward affair, but i will add instructions & tips once i get the time. Assembly instructions:Gather your printed pieces + the LED kit 2. First assemble the shaftThis may take some force, i personally just pressed them in using my thumb and guiding the pieces with my other hand 3. Attach the top most joint (the one with the square top)I pressed this in place using a flat hard surfacealign all th