Thingiverse
Post-it_tray_4x6_4x4_Stack
von CDR1124
4
Downloads
7
Likes
0
Makes
A simple tray to hold Post-It Notes 4x6. Vary basic and useful.
Update 5/18/2024 - Added a 4x4 tray. Where to put the 4x4 tray but on top of the 4x6 tray of course. Also added the stacked version.
Printing the stacked version requires support for the top tray. May not fit the build plate with the supports so block all supports in front and back. Use tree supports from the build plate so they come up from the sides (see picture).
Update 5/18/2024 - Added a 4x4 tray. Where to put the 4x4 tray but on top of the 4x6 tray of course. Also added the stacked version.
Printing the stacked version requires support for the top tray. May not fit the build plate with the supports so block all supports in front and back. Use tree supports from the build plate so they come up from the sides (see picture).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
