Pot for Large brick flower

I made a simple pot to go with glx0711's excellent Large brick flower. I liked his block as a pot but wanted something that looked more like a flower pot. At 100% the stem at 100% should connect snugly onto the flower pot.

This was just a simple flower put put together in tinkercad using the single 1x1 piece from the original design to make the connection. I'm new to designs so it is probably full of problems but it worked for me.

I printed a few for some family members but dropped the pot a few millimeters down below the bed in cura to save some filament and that worked well too. The one in the picture is the full pot.

Ignore the layer shift or whatever that is halfway down...

Also, think I originally printed with .4 nozzle at .2 height but in subsequent ones I did with a .6 nozzle to go a little faster.

I went overkill originally on infill thinking I needed the weight to prevent the flowers from tipping but it doesn't really need that much weight since the base is