Thingiverse
Pot Lid Holder
von Daxarr
90
Downloads
56
Likes
0
Makes
Design loosely based off an old pot lid holder we only had 1x of.
Print vertically at 100% infill with no supports.
Mount with double-sided adhesive or by screwing through the center.
Print vertically at 100% infill with no supports.
Mount with double-sided adhesive or by screwing through the center.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
