Thingiverse
Pot Light Trim
por Sagwan
6
Descargas
9
Likes
0
Makes
### Pot Light Trim Replacement
This was made to replace a pot light cover that was 153 mm or about 6 inches wide. This object covers the ceiling and goes on top of the cover as seen in the photo. It was made to replace the old one which was very hard to find in store. I hope it may come to be useful to someone else.
___
_***Printing notes:*** I would use support as there is a tiny bit of overhang on the middle edge. No rafts are used because this object takes up most of the build plate surface. Make sure to level before you print the object. The print will use about 30g of filament._
___
This was made to replace a pot light cover that was 153 mm or about 6 inches wide. This object covers the ceiling and goes on top of the cover as seen in the photo. It was made to replace the old one which was very hard to find in store. I hope it may come to be useful to someone else.
___
_***Printing notes:*** I would use support as there is a tiny bit of overhang on the middle edge. No rafts are used because this object takes up most of the build plate surface. Make sure to level before you print the object. The print will use about 30g of filament._
___
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
