Potensic ATOM / ATOM SE Controller Strap

It is used as a strap for Potensic ATOM / ATOM SE Controller strap. It is hanged in the sliding area of the controller ( that you stretch it to lay your phone inside the controller ). This design shifted the hole ( used for hanging the neck lanyard ) to the right to make it as much as we can to the middle of the controller after you put your phone.

Printing Settings:
3 shells ( ~ 1.5mm thickness)
30% infill
medium quality (at 0.15mm layer height )
No support

It is recommended to use 2 pieces of foam sheet ( 2cm x 1.4cm ) and stick them inside the two outer grooves. It will make the strap sturdy and not sliding at all..