POTP Volcanicus THIGHMASTER

This is a pretty straightforward design for a couple of filler pieces that fill out Volcanicus's thighs and allow him to carry a couple extra Prime Masters or Titan Masters. They simply press-fit onto the sides of Volcanicus's thighs and stay in via friction. Enjoy!!!

I would print these at a layer height of 0.1 to 0.27...0.2 gives a nice finish. They can be printed as-provided using supports, though, I would recommend printing each one in two pieces to avoid the need for supports...this will require that you glue them together afterward. One piece should include the back plate and connecting tabs on the rear and the other piece should include at least a bit of the back plate as well as the rest of the part.