Thingiverse
Potty Pops
by bllong
6
Downloads
6
Likes
0
Makes
Was inspired from something my wife showed me on facebook. Made this to help potty train our youngest.
Printed this all in PLA, printed words twice in different colors and alternated the letters, The letters should just "pop" in, I had to clean out the indentation a little first, but then just set them in and pushed them down on the table.
Do Note: I have not perfected the suckers yet, they do not go in quite right, but just the stick part sticking in I thought looked good enough for my purpose.
Printed this all in PLA, printed words twice in different colors and alternated the letters, The letters should just "pop" in, I had to clean out the indentation a little first, but then just set them in and pushed them down on the table.
Do Note: I have not perfected the suckers yet, they do not go in quite right, but just the stick part sticking in I thought looked good enough for my purpose.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!