Slicer Discord
Power and HDD LED  – 3D-printbaar model van MakerWorld MakerWorld
Electronics

Power and HDD LED

3 Downloads
1 Likes
1 Makes
Model downloaden
An accessory for my build. Check out my post!Power and HDD Led cover or casing for my open case pc (MATX).=================================================================== Important, please take note :Print with transparent material (PETG or PLA).You can always customize the Sparse Infill Pattern to your liking (Stock = Grid)Ensure that your mobo JFP1 pins provides 5 Volts or this will results in the use of different types of resistor. Check your mobo specs or you'll end up with dead LEDs.For LED : Use 2 regular 6mm LED (colour of your choice or both blue as mine)330 ohm resistors soldered at each anode (+) X 2Some heatshrink tubes to tidy it upGlue (Optional, my LEDs just stuck in there)Notes : 330ohm resistors works with most LED colour.
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, PETG, Polycarbonate
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie