Thingiverse
Power cable storage hooks
by TVPE
0
Downloads
0
Likes
0
Makes
Set of hooks for dangling short power cables by the plug, against a wall.
(specifically designed for Neutrik PowerCon True1 TOP)
Should fit any cable width less than 10mm in diameter.
Cables with a head 10-26mm in diameter should fit within the cup, less than 10mm will fall through.
Cables with a head 10-38mm in diameter, the cable strain relief should fit, but the rest may sit above cup
Cables with a wider head than 38mm may touch the adjacent cable.
Doesn't need supports if printed with the screw hole down.
(specifically designed for Neutrik PowerCon True1 TOP)
Should fit any cable width less than 10mm in diameter.
Cables with a head 10-26mm in diameter should fit within the cup, less than 10mm will fall through.
Cables with a head 10-38mm in diameter, the cable strain relief should fit, but the rest may sit above cup
Cables with a wider head than 38mm may touch the adjacent cable.
Doesn't need supports if printed with the screw hole down.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
