power cage wire guide/holder

if you have wires on your power cage or squat rack, for cameras or speakers, this holds them in place using the boltheads on the inside of the cage, that holds the pegs you put the weight plates on.

I've tried to make it easy to put on and take off, but its more of a set it up and leave it thing, if it breaks, just print another lol

the little random sticking out pieces are finger grips,

dimensions are 6.1cm inside 7cm outside

for the corner pieces: inside 6.1cm x 7.1cm

print 3 walls, and make sure the clips are horizontal so when you pull back to put wires in it doesnt snap easy, any filament