Power Control for Kobra 3 with Dual Stack and Single Stack.

Kobra 3 Smart Power Strip, 4 USB Ports and 3 AC Outlets To make is easier I created this power strip support for the DEPOW power strip. It has plenty or AC outlets and a few spares for LEDs of various types. It also has for USB ports when needed for the printer LED. https://www.makeronline.com/en/model/Kobra%203%20LED%20Light%20Support/60110.html Used with Dual Stack ACE PRO and Single Stack. https://www.makeronline.com/en/model/ACE%20PRO%20%E2%80%9CDual%20stack%E2%80%9D%20with%20slide%20out%20lower%20tray/47027.html Turn the Kobra 3 printer, ACE PRO or lights on/off with single switch. This model mounts the power strip next to the ACE PRO where everything can plug in. Print and attach the power strip support model to either side of the Dual Stack or Single Stack with 4 M3x16 screws. Link below. Put 2 M3x8 FHCS screws into the support and slide the power strip onto the support. I would recommend pointing the AC power cord out the back. Plug in the printer and upto 2 ACE PRO units and you are ready to go. Get the power Strip here. Affiliate link: https://amzn.to/3VlFVX5 This model requires 4 M3x16 SHCS screws. Affiliate Link: https://amzn.to/40nIDyz This model requires 2 M3x8 FHCS screws. Affiliate Link: https://amzn.to/4gnT37I I included the step file so it can be changed if needed.