Power distribution board for "Hypercube Evolution Complete Hotend Assembly"

Power and sensor distribution board designed for Hypercube Evolution Complete Hotend Assembly --> https://www.thingiverse.com/thing:2617424

Includes all the Gerber fil & BOM necessary for manufacturing and also the 3D part necessary for cable tightening

Connectors: XH-(x)A, VH3.96MM and MicroFit 3.0
Cable: AWG 22 - 24, 8 core wire, AWG 20 - 22 for Extruder heater

Limitation: Fan's and the heater must be rated for the same voltage (12 or 24V) otherwise will not work ( all the magic smoke will be released)

PCB can be ordered from any manufacturer, ex: JLCPcb (2 to 5 Euro / 5pcs)
XH-(x)A --> http://tiny.cc/kp1gnz
VH3.96MM --> http://tiny.cc/8m1gnz
MicroFit 3.0 2x5pin --> http://tiny.cc/2w1gnz

Pay special attention to the polarity of the heater wire polarity. The common wire between heater and fan's is the POSITIVE wire.

Please be aware that between the picture and the Gerber files the extruder wires are switched, Gerber's are the correct ones.

Fo