Thingiverse
Power Distribution board
by velluu
1
Downloads
1
Likes
0
Makes
Hello!
Made this model to easily distribute 230VAC voltage inside my Anycubic Predator. It has L, N and Ground connections and idea is to add M5 Screw to the fitting hole and then add the wires via abico- connectors. Please see the attached photo.
In the bottom there are slots for neodym magnets to give it good grip on metallic plates. size is 5x3x10 mm. For example this: https://www.banggood.com/50pcs-N48-Super-Strong-Block-Magnets-10mm-x-5mm-x-3mm-Rare-Earth-Neodymium-Magnets-p-1032976.html?rmmds=search&cur_warehouse=CN
It works great and because of the design one cannot easily insert their finger and get electrocuted from it. Lid is a bit tight but can be removed when adding or removing cables.
I take no responsibility reagrding this design. It has worked great with me but cannot give guarantee.
Made this model to easily distribute 230VAC voltage inside my Anycubic Predator. It has L, N and Ground connections and idea is to add M5 Screw to the fitting hole and then add the wires via abico- connectors. Please see the attached photo.
In the bottom there are slots for neodym magnets to give it good grip on metallic plates. size is 5x3x10 mm. For example this: https://www.banggood.com/50pcs-N48-Super-Strong-Block-Magnets-10mm-x-5mm-x-3mm-Rare-Earth-Neodymium-Magnets-p-1032976.html?rmmds=search&cur_warehouse=CN
It works great and because of the design one cannot easily insert their finger and get electrocuted from it. Lid is a bit tight but can be removed when adding or removing cables.
I take no responsibility reagrding this design. It has worked great with me but cannot give guarantee.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
