Thingiverse
Power Jack inverter mounting bracket
von sschm9
3
Downloads
4
Likes
0
Makes
I was unable to find a mounting bracket for any of these inverter's (most people seem to sit them on a shelf or bench) so decided to design one.
The STL was updated after I printed the ones in the pictures, the M8 screw holes were slotted to allow for some adjustment if the wall mounting holes are not accurate enough
Printed with 6 x 0.5mm perimeters and 25% infill for high strength (these inverter's tend to be extremely heavy due to the large ferrite transformers)
Also added a third bracket under the inverter for safety
The STL was updated after I printed the ones in the pictures, the M8 screw holes were slotted to allow for some adjustment if the wall mounting holes are not accurate enough
Printed with 6 x 0.5mm perimeters and 25% infill for high strength (these inverter's tend to be extremely heavy due to the large ferrite transformers)
Also added a third bracket under the inverter for safety
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!