Thingiverse
Power Strip Support For Computer Table
di aasisodiya
0
Download
0
Likes
0
Makes
Power Strip Support For Computer Table
- Had to brake it in parts and then assemble it using superglue
- Tried Printing in one go but i was facing issues with my filament at the time
- Once Printed you will need 8 - 12 powerful magnets of 1cm diameter and 2mm thickness
- You can use "Magnet Support.stl" to test if the magnet can fit before printing the whole thing
- Will have to insert those magnets in the circular hole of the "Strip Support" and hammer them for tight fix.
- Then Super glue the Gripper and Gripper V2 (if needed) to the "Strip Support"
- Had to brake it in parts and then assemble it using superglue
- Tried Printing in one go but i was facing issues with my filament at the time
- Once Printed you will need 8 - 12 powerful magnets of 1cm diameter and 2mm thickness
- You can use "Magnet Support.stl" to test if the magnet can fit before printing the whole thing
- Will have to insert those magnets in the circular hole of the "Strip Support" and hammer them for tight fix.
- Then Super glue the Gripper and Gripper V2 (if needed) to the "Strip Support"
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!