Power Strip Wall Mounts (Masterplug Style)

Needed to mount some power strips to the wall as part of an office tidyup and didn't find anything that already existed. I hate using the screw mount holes on the rear as its always tough getting screws accurately measured & drilled especially in tight corners and I've had occasions where once on they don't come off!

Type A was for a 2-gang 60mm x 31mm strip.
Type B is for a Masterplug SurgeGuard that is 60mm x 26mm but has a 1mm raised area where the cord comes in so needed a custom end for that.

Screws used are 3mm diameter and I've recessed for a 5mm tapered head.

Print flat and allow supports if you want to prevent any overhand issue in the screw holes.