Thingiverse
Power Supply Case
0
Downloads
0
Likes
0
Makes
I made a power supply case to cut down on the cost of my project's enclosure. Now I have 2 aluminum case for the price of one plus some filament.
This enclosure utilizes half of a box aluminum found on digikey:
https://www.digikey.ca/en/products/detail/bud-industries/CU-3009-A/387015
The window is for a TFT module you may purchase on amazon https://www.amazon.ca/dp/B07WDJ3TV6?ref=ppx_yo2ov_dt_b_fed_asin_title
Use a 5x7" 0.043" acrylic sheet for the lid.
Brass M3 inserts were installed onto the front and back panel screw holes.
I found the M3*8 screws and washers to be optimal for this build.
This enclosure utilizes half of a box aluminum found on digikey:
https://www.digikey.ca/en/products/detail/bud-industries/CU-3009-A/387015
The window is for a TFT module you may purchase on amazon https://www.amazon.ca/dp/B07WDJ3TV6?ref=ppx_yo2ov_dt_b_fed_asin_title
Use a 5x7" 0.043" acrylic sheet for the lid.
Brass M3 inserts were installed onto the front and back panel screw holes.
I found the M3*8 screws and washers to be optimal for this build.
TheLittleTinkerer also publishes on
5 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
