Power Supply Mount Case Hypercube modified V1.3

Modified the original file to accept a different power plug and switch. (this set of switch and plug was sent to me by Geeetech by mistake and had it laying around)

25/02/17 Update #1: Printed a test panel (Image1.jpg) and looks like a good fit.

26/02/17 Update #2: Printed prototype, not quite good fit on my power supply and need more room for wires inside. So now testing V1.2. Made more room (length wise when upright, adjusted and elongated power supply screw holes. Will print and test soon.

27/02/17 Update #3: Version 1.2 works great. Fits good on the power supply, and lots of room for the wires inside. Only down side is the access hole to adjust the voltage is at an angle view now. I modified the hole position in V1.3 but I will keep the printed V1.2 as it took quite some plastic and it is good enough for me ;-)

03/04/17 On special request I made a "side " version of the switch and power inlet. It's V1.4, Enjoy


Cheers


A big thank you to Tech2C