Thingiverse
Power Supply Wall Mount
door DaBayer
12
Downloads
9
Likes
1
Makes
This is a wall mount for a power supply brick that measures 32mm x 56mm x 127mm. The opening at the "lower" end is sized such that it can accommodate a 120VAC power cable centered on the end or the low voltage DC power just as easily.
This mount was designed to allow the power supply to slide down from the top to direct the low voltage lead upward to an RGBW LED strip controller and alleviate strain.
The screw holes are 4mm and feature a 3mm x 8mm countersink.
Designed in TinkerCAD as my first CAD project as well as 3D print project.
Printed in the orientation provided, no supports are required.
My part cooler fan died near the beginning of the print, so strings were literally everywhere. After cleaning it up, the resulting mount was snug enough that I'm sure the power supply won't fall off the wall again any time soon!
This mount was designed to allow the power supply to slide down from the top to direct the low voltage lead upward to an RGBW LED strip controller and alleviate strain.
The screw holes are 4mm and feature a 3mm x 8mm countersink.
Designed in TinkerCAD as my first CAD project as well as 3D print project.
Printed in the orientation provided, no supports are required.
My part cooler fan died near the beginning of the print, so strings were literally everywhere. After cleaning it up, the resulting mount was snug enough that I'm sure the power supply won't fall off the wall again any time soon!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!