Slicer Discord
powerful sugar rocket – Modèle 3D imprimable de MakerWorld MakerWorld
Sport & Outdoors

powerful sugar rocket

10 Téléchargements
8 Likes
0 Makes
Voir le modèle
a sugar rocket requires a launch rod 10 mm or smaller flies about 300m fully packed. also i use a 65 35 ratio of 65 potassium nitrate and 35 sugarto use: put rocket fuel in the back BEFORE putting the nose cone on then pack the rocket fuel repeat 2-3 times till about 2cm and then get the nozzle put super glue ALL over the outside and put it in with the LONG side facing in so the short side is on the outside of the rocket. - if the nozzle is a tight fit tilt it on a 45 degree angle put it in then grab a hammer and hit it till it moves and becomes flat put the top on then put the fuse or sparkler in the bottom, slide the rocket down light it and RUN this could explode so go far and watch it woosh. (by the way it would be nice if you commented that it worked for you and if not i can change the design)
Catégorie
Sport & Outdoors
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Post-traitement
Collage
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection