Thingiverse
PowerPlug smartphone support
4
Downloads
1
Likes
0
Makes
I have printed the smartphone holder from XRCONTROL to get my smartphone hanged by the power plug. but it was too big (not the good form factor).
So i made a very simple one. Cura told me that it would need around 5h to print with 0,2mm.
No name and you can customise the smarphone dimension by opening the Freecad file.
You can try to print it vertically or flat to the plate.
I also made an enhaced version, by adding some kind of round shape into the angle > it happened that the 3 fingers did break. So I hope this would be more ruggedised now.
With a "low quality" print (large steps to get something stonger) the print time is only 2h36 (anounced by Cura).
So i made a very simple one. Cura told me that it would need around 5h to print with 0,2mm.
No name and you can customise the smarphone dimension by opening the Freecad file.
You can try to print it vertically or flat to the plate.
I also made an enhaced version, by adding some kind of round shape into the angle > it happened that the 3 fingers did break. So I hope this would be more ruggedised now.
With a "low quality" print (large steps to get something stonger) the print time is only 2h36 (anounced by Cura).
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
