Thingiverse

Practical super-capacitor array enclosure (1x6, 16.2v)

von wubwub89

15 Downloads

13 Likes

0 Makes

This is a simple, and hastily drawn, enclosure for one of my many super-capacitor arrays, specifically six 500F in series WITH management board, totaling ~83F. The pictured unit will be going on the 12 volt side of my printer to alleviate print failures caused by brownouts. Please note, I am not driving a heated bed with this. Since my printer uses a 10kg+ aluminum plate for a bed, I am using 800w of heating elements on AC via MOSFET control. While a supercap array can drive those heaters, it would not last very long before the printer crashes. Supporting the hotend and steppers would be suitable. I will be limiting my output current to around 4.8 amperes, with a 7.5 ampere blade fuse, utilizing SWG 16 stranded wire. Without current limitation, you'd basically be exposing your power supply to a dead short, practically speaking, until the unit starts gaining stored current. Without fusing, you risk a very rapid discharge, which will vaporize heavy wire, throw small bits of molten metal,

backup battery backup power case enclosure energy green energy power power supply power supply cover supercapacitor UPS backup battery backup power case enclosure energy green energy power power supply power supply cover supercapacitor UPS

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat