Thingiverse
Pre-Bonsai Roots Guide
von fcc92
18
Downloads
16
Likes
0
Makes
Comes with five holes. The centered one is for a fastener bolt to the main trunk of the bonsai, the other four holes are intended for wires.
Total Diameter: 130mm
Total Height: 8,5mm
Holes diameter: 2mm
Print Settings Used:
0.4 Nozzle
0.3 Layer Height
4 to 5 Walls
4 Top
4 Bottom
30 % infill
This is my first upload to thingiverse. Enjoy !
Total Diameter: 130mm
Total Height: 8,5mm
Holes diameter: 2mm
Print Settings Used:
0.4 Nozzle
0.3 Layer Height
4 to 5 Walls
4 Top
4 Bottom
30 % infill
This is my first upload to thingiverse. Enjoy !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
