Precise Time fuse cutter

Tools needed:

1/4" drill bit to clean bolt holes and adjuster hole

19# drill bit for m5 tap

6# drill bit to clean up blade clamp holes

M5 tap (#19 drill bit for this tap size) for adjuster lock and clamping area

Hardware:

screws to mount it #8 work well

1/4" brassrod

1/4x4" bolt with lock nut and 2x washer

superglue for knob

M5x20-30 x3

(print at 60% with thicker walls for the best rigidity)

Anvil Single Edge Razor Blade x1 (remove the aluminium cap off razor before installing)

Cuts as accurate as you are! I hope everyone enjoys my little contributions to our hobby.

let me know how you like it.

top measure lines are in half cm bottom is 3mm 1/8"



Big thanks to whispercleave for helping with the prototype!