Thingiverse
Predator 212 Oil Cap
di Bomberguy111
14
Download
28
Likes
0
Makes
This is an oil cap for a Predator 212 engine. (Would probably fit other predator engines)
Fits just fine. From my research, oil in small engines reaches about 300F at its hottest. PLA starts to melt at about 338, so in theory this cap shouldn't melt. It has not been tested in those conditions though. I am not responsible for any damages that could occur from using this cap. In the end though, I don't think it would be a problem at all. I would recommend adding an O-ring or some sort of seal to it.
Fits just fine. From my research, oil in small engines reaches about 300F at its hottest. PLA starts to melt at about 338, so in theory this cap shouldn't melt. It has not been tested in those conditions though. I am not responsible for any damages that could occur from using this cap. In the end though, I don't think it would be a problem at all. I would recommend adding an O-ring or some sort of seal to it.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
