Premium Taco Holder

About:
=======

I Liked the basic Design of Barspin's Taco Holder, but I thought is was a bit short, and a bit thin and weak.

Holds 3 Tacos one way, flip it over if you only want to hold 2

My revision is much wider for supporting soft tacos, and also much thicker and less likely to get broken.

The trade off is a much longer print time.




Print Recomendations:
=================

- 0.2mm layer height

- 0.4mm nozzle

- 4-5 shells/walls (whatever it takes to make it solid in your slice preview. We want any small voids to just stay small surface voids, not inlets to an interior chamber that fills with water while washing the holder. I suggest shells over infill because most slicers will want to put micro zigg zaggs to solid fill, a shell will be much easier on the printer since it will print in long smooth movements.)

- Select inside out printing. This way any minor over-extrusion will just grow the part a tad, which is fine since Taco holders don't