Presence Sensor Housing

This is a housing for a 30-pin ESP32 with USB-C, an HLK-LD2450 mm wave radar sensor kit, and the sensor's Bluetooth antenna. The other housings I found put the radar sensor behind the ESP32, which seemed like it could cause interference. The foot of the other model didn't work very well either, so I decided to make my own.Designed for the ELEGOO ESP32 (https://a.co/d/cwva4je) and HLK-LD2450 kit (https://a.co/d/dWxw6Zg) but most 30-pin or 32-ping ESP32s should fitFront face design falls below the interior of the housing to help hide the USB-C connectionVented on the sides and back so it has air flow even when stuck flat to a wall or into a cornerFoot is removable and clips onto the side ventsFoot height is also adjustable so the gap can be sized properly to fit your USB cableLid is a friction fit and is overlapped along the front to prevent LED light from shining throughTo assemble:Insert the ESP32 first. Gently wiggle the ESP32 side-to-side to get the support fin between the ES