Thingiverse
Pressing plate
von magomi
4
Downloads
5
Likes
0
Makes
Needed a plate to reattach the cap at my wifes watch after changing the battery.
Outer diameter 35.3 mm, inner diameter 32.0 mm, angle of the bevel 23.2°.
The plate is designed to only touch the bevel so the glass of the watch is safe when putting pressure to snap the cap close.
Set infill density to 100 % to make sure the pressure is well distributed and the plate does not crash during pressing.
Outer diameter 35.3 mm, inner diameter 32.0 mm, angle of the bevel 23.2°.
The plate is designed to only touch the bevel so the glass of the watch is safe when putting pressure to snap the cap close.
Set infill density to 100 % to make sure the pressure is well distributed and the plate does not crash during pressing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!