Thingiverse
Pressure advance test print
door teikjoon
11
Downloads
4
Likes
0
Makes
Test print for pressure advance (klipper firmware), but would probably be useful for Marlin's Linear Advance as well.
I add the command :
SET_PRESSURE_ADVANCE ADVANCE=0.100
At every 25 layers (5mm) and increse this value by 0.1, which gives me a range of 0.0 to 1.9
You can also scale the print down to test single pressure advance values.
Best printed with brim, because its very thin and you're not really testing bed adhesion with this print.
I add the command :
SET_PRESSURE_ADVANCE ADVANCE=0.100
At every 25 layers (5mm) and increse this value by 0.1, which gives me a range of 0.0 to 1.9
You can also scale the print down to test single pressure advance values.
Best printed with brim, because its very thin and you're not really testing bed adhesion with this print.
teikjoon publiceert ook op
3 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
