Pressure Washer Accessory Kit

Pressure Washer Accessory Kit

• M22 Caps
• Storage box
• Mounting bracket

Caps are M22 which should fix most pressure washers.

I designed the bracket and box for my Pressure Washer which is a Snapper 3,100 PSI Pressure Washer Model 020794-00.

The hinge pin for the box is a little tight, but it loosens up after working it a bit. The hinge pin cap is a little loose, I intended to glue it in anyway.

The mounting bracket has slots on the top and bottom to slide a zip tie through if I need to fasten it to the handle if it slides around during operation.

The mounting bracket clips on center support of the handle with no tools or drilling required. The box mounts to the bracket with four small screws you can find at any hardware store.

All in all, it took about 48 hours to print 7 caps, the box, lid, hinge pin, pin cap and mounting bracket on an Ender 3 Pro in super quality. The box, lid, and bracket will need support. I used the tree support option, which worked well.