Thingiverse
Pressure washer trigger lock
von mwiesenhaan
5
Downloads
5
Likes
0
Makes
Was getting sore hands from holding the trigger of my pressure washer for hours and hours while cleaning. This design suits common commercial pressure washers.
Width of the handle : 30mm
Thickness : ~7mm
Requires 2 pcs of M5 x 35mm bolts
I printed in PETG with 15% infill and does the job. Make as heavy/strong as you feel is required.
Width of the handle : 30mm
Thickness : ~7mm
Requires 2 pcs of M5 x 35mm bolts
I printed in PETG with 15% infill and does the job. Make as heavy/strong as you feel is required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!