Pricing display

Pricing display that I made for my buddy. The model that has sides, keeps the pricing and item description pieces secured in the display with a removable side held on by 4 magnets. Both versions will stand up without the feet on them. If you are going to be using it outside or on a table that might get bumped I would suggest using them. Display with sides:I used 4 magnets to secure the one side on. The size of the hole is 8.75 mm wide by 3.2 mm deep and glue will be needed.I did the infill on this at 20%. You can change it back to 15% if you want to save on filament. I only did it for a little extra weight when not using the feet. The side piece that attaches with magnets is also not necessary if you want to save on filament. I only made that so if it fell off a table the pieces wouldn't slide out. Display with no sides:I did the infill on this at 25% for the extra weight. You can change it back to default if you want to save on filament and time. This will use less filament than t