Prime Radiant

This is a very delicate print, designed for resin. The dxf file is for laser cuts, each side is 44.9mm and the *edges* only are bonded (I use WeldOn 3). See this video for a better idea of what it's about. https://www.youtube.com/watch?v=BQjSwPJL_rI

I left off the symbols on the sides, as I never really liked them.

The clear resin can be anything clear, but I use CrystalClear 204 from Smooth-On. Do not pour all at once, pour in 3-4 increments.

Note: for the last facet, make sure you pour the resin right up to the inner edge and let it cure; it will be slightly concave. Then, sand the acrylic down to that edge. Add a last small pour of resin, then cap it with another piece of acrylic, working any bubbles out. Let it cure a good long time before peeling away the acrylic facets.