Thingiverse
Primer Tube Cap
por Chrossphyre
23
Descargas
10
Likes
0
Makes
This is my first design from scratch. Simple, I know, but give me credit for trying! I needed caps for my primer tubes so I could load them up for a session without fear of spilling primers all over the place in the event of a mishap. These are just the right tension on the primer tubes I have for my Hornady LNLAP press. PLA shrinkage accounted for.
Chrossphyre también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!