Toys & Games
Go to Model
Princess Castle Remix
565
Downloads
469
Likes
4
Makes
About 105 hours and 1486 grams of PLA. Mostly printed at 10% down to 0% fill. I modified it to make it 3 levels just because I thought it would be more fun. I scaled each piece down a little so it would fit my printer. It ended up being about 20"x13" and 30" tall. Door openings are all big enough for the Disney dolls 4 inches, except the front gate was a little short. I included a Blender file where I modified it - I was in a rush to do this so it's not perfect, but my daughter couldn't tell, she loved it! (Thank you mgros!)
If I were to do it over again I'd model it so you could snap it together. The glueing was the hardest part, but then again I only tried Loctite super glue and hot glue. The super glue had to be held firmly for 10 or more minutes and then left alone for hours and still a weak bond.
Printed on glass heated bed
Clear PLA (looks like ice! If I printed much higher speed than 40 it lost a lot of the gloss - mostly printed at speed 30)
Walls at 10% fill seems to b
If I were to do it over again I'd model it so you could snap it together. The glueing was the hardest part, but then again I only tried Loctite super glue and hot glue. The super glue had to be held firmly for 10 or more minutes and then left alone for hours and still a weak bond.
Printed on glass heated bed
Clear PLA (looks like ice! If I printed much higher speed than 40 it lost a lot of the gloss - mostly printed at speed 30)
Walls at 10% fill seems to b
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!