Thingiverse

Print head for Hypercube Evolution

von madlex

13 Downloads

11 Likes

0 Makes

About
***
This is a hotend cover I designed for Hypercube Evolution to mount all the print head ventilators onto it. It connects to the "Extruder Mount" via two screws and it will replace your usual extruder clamp. It uses two side turbo fans for part cooling and one 40 mm fan for cooling the coldend.

The opening behing hotend, previously used in the original design to connect the 50mm turbo fan, can be repurposed as channel to route the hotend wires through it.

Check out this presentation video: https://www.instagram.com/p/CBQ-lsZloO0/

Follow
***
I also post pics and videos of my designs on my [Instagram](https://www.instagram.com/madxfpv)

Extra
***
On the top it has four 5 x 5 mm holes to insert neodium magnets for attaching a cap (that I haven't designed yet). You can also use this holes for brass inserts, to connect other things.

On the sides, each vent has four 5 x 5 mm holes for brass inserts, with the same purpose.

I also attached a strip of neopixels to

cooling E3D E3D Hotend extruder hevo hotend hypercube hypercube evolution mount printhead Ventilation cooling E3D E3D Hotend extruder hevo hotend hypercube hypercube evolution mount printhead Ventilation

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat