printability fix for Examon

This is a page for fixing some digimon models for printability as requested by shadowforcelaws. Third up, Examon!

This one wasn't so bad. It stands head height at 46mm. The wings add 18.1mm though for a total of 64.1mm tall.

Most of the parts only needed slight thickening. The teeth had to be completely replaced. Also the tail ring had some struts added so that the ring was not floating unattached in space.

It was a little annoying that all the wings, arms, and legs were not perfectly symmetrical, so I couldn't just mirror the left side of the body onto the right.