Thingiverse
Printable Desk Clamp
von zignig
388
Downloads
352
Likes
0
Makes
A small desk clamp.
Works but it requires a little more super glue than I would have liked.
It was designed to be a PCB holder (the one Lady Ada uses in her instructions was the inspiration).
http://www.ladyada.net/images/usbtinyisp/tools.jpg
The base is too small making it unstable.
However I just finished printing it and it works!
To make it you will also need.
3/8 (5mm will do as well) threaded rod and some square nuts.
Square brass tubing ( 3.9 mm ) and the size that fits just inside that.
Needs some more work:
Bigger base , maybe multipart
Better way to hold the clamps
The tar file contains the blend , photos and all the stl files.
Works but it requires a little more super glue than I would have liked.
It was designed to be a PCB holder (the one Lady Ada uses in her instructions was the inspiration).
http://www.ladyada.net/images/usbtinyisp/tools.jpg
The base is too small making it unstable.
However I just finished printing it and it works!
To make it you will also need.
3/8 (5mm will do as well) threaded rod and some square nuts.
Square brass tubing ( 3.9 mm ) and the size that fits just inside that.
Needs some more work:
Bigger base , maybe multipart
Better way to hold the clamps
The tar file contains the blend , photos and all the stl files.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
