Thingiverse
Printable egg-bot legs
von jhitesma
49
Downloads
20
Likes
0
Makes
I had some really ovoid plastic eggs I wanted to print on and needed to lower my pen arm so the bottom of it was below the base of my egg-bot. I kind of wanted the whole thing higher anyway for better ergonomics.
These are included in the onshape design of my re-redrawn eggbot (included as a source here) if anyone wants to modify them.
Should work on any eggbot that uses this same spacing between the bottom rails.
These are included in the onshape design of my re-redrawn eggbot (included as a source here) if anyone wants to modify them.
Should work on any eggbot that uses this same spacing between the bottom rails.
jhitesma veröffentlicht auch auf
21 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
