Thingiverse
Printable Phone Stand
por ab86uk
15
Descargas
5
Likes
0
Makes
***Not another phone stand!*** Yes, OK. I just couldn't find one which was both easily 3D Printable and holds the phone high enough to charge while it's on the stand.
There is an aperture below the phone to allow the phone to be connected to power/usb. A hole is included in the back to allow the cable to pass through.
The stand is 7cm wide and 7cm deep. The shelf for the phone is 1cm deep, so should fit most smartphones even with a cover on. Without a phone, the stand is 10.5cm tall.
I've included the FreeCAD file if you want to make changes.
There is an aperture below the phone to allow the phone to be connected to power/usb. A hole is included in the back to allow the cable to pass through.
The stand is 7cm wide and 7cm deep. The shelf for the phone is 1cm deep, so should fit most smartphones even with a cover on. Without a phone, the stand is 10.5cm tall.
I've included the FreeCAD file if you want to make changes.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
