Thingiverse
Printable RC Filter Redux
por clothbot
6
Descargas
7
Likes
0
Makes
This is a derivative of http://www.thingiverse.com/thing:2967
I saved the SVG out of InkScape as DXF and cleaned it up in QCad so it would extrude cleanly in OpenSCAD.
The STL is just the pattern scaled down by a factor of 10 (now 2mm trace width) and subtracted from a 10mm*20mm slab.
The license was CC-By-NC-SA.
Aside: I'll drop the license to CC-By-SA if the source decides at some point to do the same. I try to restrict my own "NC" license usage to finished designs, not building blocks. Much more infectious that way. ;-)
The license is now is now inherited CC-By-SA!
Aside 2: License updated to reflect CafeT's change. Let the infections begin!
I saved the SVG out of InkScape as DXF and cleaned it up in QCad so it would extrude cleanly in OpenSCAD.
The STL is just the pattern scaled down by a factor of 10 (now 2mm trace width) and subtracted from a 10mm*20mm slab.
The license was CC-By-NC-SA.
Aside: I'll drop the license to CC-By-SA if the source decides at some point to do the same. I try to restrict my own "NC" license usage to finished designs, not building blocks. Much more infectious that way. ;-)
The license is now is now inherited CC-By-SA!
Aside 2: License updated to reflect CafeT's change. Let the infections begin!
clothbot también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
