Thingiverse
Printable Trumpet Version 2
von LtDan
3.2k
Downloads
2.7k
Likes
14
Makes
This is my second go at designing a printable trumpet. Unfortunately none of the old pieces will be compatible with the new version aside from the mouthpiece I guess.
I finished this as of 7/14/15. It still doesn't sound great but that's not incredibly surprising. [video](https://www.youtube.com/watch?v=dah3trT5Tkk)
What I changed?
- I increased the diameter of the tubes especially in the middle bit and made them circles instead of stupid ovals. Should still print fine without supports.
- The entire thing should be more printer friendly. Most of the pieces are 5 inches or less with the tallest one being about 5.6 inches. If that is still an issue let me know.
- You don't need rubber bands to hold the valves down assuming you find adequate springs to push the valves up. Still may need rubber bands to keep the tubes from wobbling about unless I or you make some sort of braces.
I finished this as of 7/14/15. It still doesn't sound great but that's not incredibly surprising. [video](https://www.youtube.com/watch?v=dah3trT5Tkk)
What I changed?
- I increased the diameter of the tubes especially in the middle bit and made them circles instead of stupid ovals. Should still print fine without supports.
- The entire thing should be more printer friendly. Most of the pieces are 5 inches or less with the tallest one being about 5.6 inches. If that is still an issue let me know.
- You don't need rubber bands to hold the valves down assuming you find adequate springs to push the valves up. Still may need rubber bands to keep the tubes from wobbling about unless I or you make some sort of braces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!