PrintABlok Boks

Box for PrintABloks that use [these](https://www.amazon.com/dp/B07KMXSLRB/ref=cm_sw_r_cp_apa_i_xKU.DbN0E69DM?th=1) 10x2mm neodymium disks instead of harder to find and more expensive 5mm spheres like the official box uses. Some tolerances added because these magnets aren't perfectly sized (I've used them before) and I suggest the use of glue.

Two versions of the box; With and without part segregation (Connectors in the small side), and a lid included. They take up about the same footprint of the OG small box, but the internal volume per box is greater.

I did not brand this box out of respect for the original design, so if you want a box that says "PrintABlok", go elseware. This was designed to solve a magnet problem, not replace or compete with the original payware.

--

If you like the design and want to support my work, throw me some crypto currency!

Bitcoin: 3QfkyjF3Z7KJcHvyb34GgPY8qAhSD3i31f
Bitcoin Cash: qzcadajt7mr5mw8ftp9s2evrd4q937n8qy603xgx86
Ethereum: 0x4659