Thingiverse
Printer Overhang calibration
von maflatlander
9
Downloads
9
Likes
0
Makes
This is a calibration piece to determine how much overhang your printer can handle.
Each rib is an additional 10 degrees, one side starts at 5, the other side at 10. The tower is full horizontal but different lengths.
Each rib is an additional 10 degrees, one side starts at 5, the other side at 10. The tower is full horizontal but different lengths.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
