Slicer Discord
Printer Side Panel Honeycomb Storage Wall – Modelo 3D imprimible de MakerWorld MakerWorld
3D Printer Accessories

Printer Side Panel Honeycomb Storage Wall

2.8k Descargas
1k Likes
1.8k Makes
Ver Modelo
I ran out of space on my wall and decided to make a HSW for the side of my printer. I have a P1S, but my understandng is the X1C has the same outside dimensions. I have no way of knowing if it will work with other printer models. It covers the whole side and is held in place by the feet of the printer. The goal was to use all the available space and not have it flopping around everytime I took something off the wall. I found that the top liked to tip forward a little, so I added a couple small clips to hold it back. You may need a little sanding on the center of the two spots the feet go if they dont slide over the feet all the way. To avoid breaking the two top clips you should install the top and bottom halfs of the panel seperately and then connect the centers. Many thanks to rostap for his work developing the Honeycomb Storage Wall: https://makerworld.com/en/models/22521#profileId-27457 You can check out the full collection of my HSW models here: https://makerworld.com/en/collectio
Categoría
3D Printer Accessories
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Lijado
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección