Printer Simple Printed Enclosure

Minimalist almost all printed enclosure for Prusa MK2S (will probably fit many other printers), with led strips, hepa + carbon filter and additional fans to protect electronics and power supply.
Work not finished, still missing the filament guide to cover the upper hole (very rough now), the clips to block the door in closed position, the clips to cover the openings between plaxiglass parts, the covers for the side openings, and an electronics box for the fans/leds connections.
But already very nice looking and working, even without being completely sealed it keeps heat inside and stabilized on a good 30-40C during 2 hours long PET print (to be better measured...).
One note, I have sorbotane supports on the bottom of the printer feets (increasing height by 1-2 cm), and when the extruder moves all way up it touches the plexiglass (upper plexiglass is ~1 mm too low). I solved by cutting 1-2 mm from the extruder top but is not very nice looking it might be better to increase box height