Thingiverse
Printgrip for slackline
von WeB_FoX
19
Downloads
20
Likes
0
Makes
Printgrip for 25mm wide webbings. WLL: 4kN.
This is an analog of linegrip.
Parts:
1. printed printgrip up and down
2. vibram two pieces 3x71x53
3. 6mm cable 1m
Slip rubber with printed parts. then you need to cut holes for the rope.
I recommend nylon before abs or pla. Because nylon is more resistant to deformation. Printed without support.
Russian Slackline community
This is an analog of linegrip.
Parts:
1. printed printgrip up and down
2. vibram two pieces 3x71x53
3. 6mm cable 1m
Slip rubber with printed parts. then you need to cut holes for the rope.
I recommend nylon before abs or pla. Because nylon is more resistant to deformation. Printed without support.
Russian Slackline community
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!